My mounts are so chewed up I can't determine the proper orientation in the mounting bracket. It looks like on the passengers side that the air gap is at the top with the rubber "foot" on the bottom. Is that correct? The drivers side I can't tell anything.
Thanks
Motor mount orientation 88 Cabby
Moderators: kamzcab86, CalAltaDubber
-
- Frozen Guy in the Northern Country
- Posts: 2012
- Joined: Thu Aug 12, 2004 11:10 pm
- What year is your cabby?: 1987
- Do you own a Cabriolet?: Yes
- Location: Calgary, Alberta, Canada
- Contact:
Re: Motor mount orientation 88 Cabby
Sounds like they are pretty beat up.
They are not that expensive to replace. I assume the engine is out of the car right now. If that's the case, it is probably worth your wile to replace them.
They are not that expensive to replace. I assume the engine is out of the car right now. If that's the case, it is probably worth your wile to replace them.
Phil
'87 Cabriolet, "Topless Bunny"
'88 Cabriolet, "Posh Bunny"
'04 Golf
'12 Golf Wagon TDI
'69 Manx type Dune Buggy (New Toy)

'87 Cabriolet, "Topless Bunny"
'88 Cabriolet, "Posh Bunny"
'04 Golf
'12 Golf Wagon TDI
'69 Manx type Dune Buggy (New Toy)


- Briano1234
- Whats that smell?
- Posts: 4105
- Joined: Mon Mar 21, 2005 5:45 am
- What year is your cabby?: 1992
- Do you own a Cabriolet?: No
- Location: Duluth, Ga
- Contact:
Re: Motor mount orientation 88 Cabby
I never can remember, but there should be an arrow on the new mount to indicate up.
But from the vintage site:
http://www.vintagewatercooleds.com/tech ... ne-mounts/
But from the vintage site:
http://www.vintagewatercooleds.com/tech ... ne-mounts/
Briano
Yes as matter of fact, I have the Luck o'the Irish...everything I touch turns to fertilizer of the bovine variety.
You can lead a user to a link, but you can't make him Click....
Yes as matter of fact, I have the Luck o'the Irish...everything I touch turns to fertilizer of the bovine variety.
You can lead a user to a link, but you can't make him Click....

-
- Posts: 16
- Joined: Sun Mar 21, 2010 7:53 am
- What year is your cabby?: 1988
- Do you own a Cabriolet?: Yes
Re: Motor mount orientation 88 Cabby
Located the arrow...good to go
Thanks
Thanks
-
- Posts: 16
- Joined: Sun Mar 21, 2010 7:53 am
- What year is your cabby?: 1988
- Do you own a Cabriolet?: Yes
Re: Motor mount orientation 88 Cabby
This is a long overdue report on my engine mount replacement. I followed Timbo's Technotes on the subject and all went well. I actually did it in stages saving the passenger side installation till last. I test drove Luvi after each mount installation and didn't find any significant improvement in idle vibration till I installed the passenger side mount. WHAT AN IMPROVEMENT!! I had read that others found the same results but I wanted to reinforce that fact. So if anyone is considering not changing out this mount because of the difficulty all I can say is yake your time ...follow Timbo's procedures and you will find the results well worth your effort. Thanks to everyone...especially Timbo's "Vintage Watercooled" for great Technotes...
Regards..
Band B
Regards..
Band B