Search found 3608 matches
- Sun Oct 14, 2018 8:42 am
- Forum: Electrical
- Topic: Dual horn - still not 100%
- Replies: 13
- Views: 9003
Re: Dual horn - still not 100%
You don't need a Torque wrench on the steering wheel nut. Just fully tighten it and then a good umph will do. On the back side of your steering wheel you will see the rub mark where the contact makes connection to the wheel. Clean this and Polish this with some 0000 steel wool, it gets greasy and ca...
- Fri Oct 12, 2018 8:05 pm
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
Check the fuse, then pull the horn relay and use a ground jumper from the 87 pin on the relay to ground, and your horns should honk, if not then it is the wires going to the horn from the relay. It they do then check the ground on the steering rack mount, to the steering gear box (under the car) htt...
- Fri Oct 12, 2018 7:55 pm
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
Rubber boot 211906101
https://www.ecstuning.com/b-genuine-vol ... 211906101/
Insulated spad connectors are a whole lot cheaper.
https://www.ecstuning.com/b-genuine-vol ... 211906101/
Insulated spad connectors are a whole lot cheaper.
- Fri Oct 12, 2018 7:50 pm
- Forum: Off Topic/Open Forum
- Topic: Your Cabriolet/Rabbit's Build Date
- Replies: 6
- Views: 8093
Re: Your Cabriolet/Rabbit's Build Date
Any thing labeled Karmann as in Ghia, I think the Camper Vans as well.
- Fri Oct 12, 2018 5:53 am
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
The horn has a full time power on it. They switch the ground via the horn relay. Take the horns off and apply Battery and ground to them from the battery, if they don't both honk loudly, bad horn. If they honk loudly then you have a issue between the horn button on the console the relay, and back ou...
- Fri Oct 12, 2018 5:40 am
- Forum: Off Topic/Open Forum
- Topic: Your Cabriolet/Rabbit's Build Date
- Replies: 6
- Views: 8093
Re: Your Cabriolet/Rabbit's Build Date
The cars were assembled from the ground up at the Karmann plant.
and it isn't had to believe that they produced cars in that number.
I had a 1981 Rabbit Diesel bought off the showroom floor in 1980 (October).
and it isn't had to believe that they produced cars in that number.
I had a 1981 Rabbit Diesel bought off the showroom floor in 1980 (October).
- Thu Oct 11, 2018 6:49 pm
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
Yep it hardens the exhaust to prevent it from breaking at the manifold connection, and allows the engine to flex on torque after the connection to the accordion pipe.
- Wed Oct 10, 2018 8:07 pm
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
That is the exhaust bracket... tain't nothing that a good welder can't fix.
- Mon Oct 08, 2018 7:17 pm
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
www.cabby-info.com has a how to on slow wipers, I have where you need to oil the frame, and yes it needs to be oiled at the pivot points.
- Mon Oct 08, 2018 7:11 am
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
I would have to look but I may have the center grille, and the lower radiator or duct cover. I moved so not all my parts are where I can find them.
- Mon Oct 08, 2018 7:11 am
- Forum: Introductions
- Topic: 1981 Rabbit Convertible... it has arrived!
- Replies: 16
- Views: 10992
Re: 1981 Rabbit Convertible... it has arrived!
The loose part is a radiator card helps direct air over the radiator by sealing off the radiator from the engine compartment. The rusty bits are available as replacement parts. hope there isn't much else under the car. The glued on wings can be replaced by the bolt one ones. Tops doesn't look like i...
- Sat Oct 06, 2018 10:25 pm
- Forum: Cabby Sightings
- Topic: Where did the Cabbies go??
- Replies: 17
- Views: 24589
Re: Where did the Cabbies go??
Well, the last time I was at a show, there wasn't any Cabby class, and they placed them in the mk1 class....
- Sat Oct 06, 2018 10:24 pm
- Forum: Introductions
- Topic: Photographic Introductions
- Replies: 10
- Views: 8386
Re: Photographic Introductions
Welcome to the friendliest Forum...
Still waiting for pics, but not as bad as you are waiting.
Still waiting for pics, but not as bad as you are waiting.
- Thu Sep 13, 2018 10:46 pm
- Forum: Cabby Sightings
- Topic: Where did the Cabbies go??
- Replies: 17
- Views: 24589
Re: Where did the Cabbies go??
Somehow I don't think I can make it
- Tue Sep 11, 2018 9:35 am
- Forum: Introductions
- Topic: Hello from VT
- Replies: 3
- Views: 4701
Re: Hello from VT
The best information site is, www.cabby-info.com Yes, your top needs to have the middle folded in so there are fold when closed, this is a sign that the straps weren't attached or they have broken allowing your top to parachute out the rear... :) Till your new top is installed you just have to push ...